Precision CNC laser cut from .250 thick 1050 High Carbon cold rolled steel. These are solid race motor mounts are for installing the 1997-2013 Gen III/IV LS series engine into older GM muscle cars. They are slotted for adjustment with engine placement in the engine compartment. These mounts will allow you to move the engine from the original bell housing position up to 2 1/2 inches forward, and up to 1/2 inch rearward. When torqued in place they do not allow the engine to move, even under high horsepower applications. Precision CNC press brake folded with large radius die to reduce stress on the bend. Some models require the use of Moroso solid frame pads, see notes at bottom. These are solid engine mounts, bolt directly to your existing frame stand, and do not use a rubber isolator. For 1958-72 rubber mounted engines we manufacture the Dingo Slider mounts- click here. May require using an aftermarket oil pan. Grade-8 zinc coated hardware including new cross bolt.

* (Raw steel not painted) Black texture powder coat is available.

* Sold in pairs, left and right. "D" is the Drivers side, "P" is the Passenger side. Arrows point forward.

* These mounts will clear low mount a/c but will not allow the engine to slide back, they mount against the a/c compressor bracket.

* These mounts will clear low mount alternators but the amount of adjustment may be limited.

-Featured in GM High-Tech Performance, Chevy High Performance, Street Rodder, and Super Chevy Magazines.

-Back to main list of Muscle Mounts-

 Adjustable Motor Mount Application Chart

These selections are based on the original engine in the car.