When installing this bracket on truck engines the upper hole is not drilled or tapped in the block.
Aluminum LS1 blocks will use three mounting holes.
Trucks will only use two, one upper and one lower.
Using the Dirty Dingo front bracket turned upside down place a transfer punch through the upper hole and mark the block.
This should be drilled with a .339 drill bit 3/4" deep and tapped with a 10MMx1.5 tap 1/2" deep.
The middle hole will not be used on the truck engines, only the top and bottom holes using the two short spacers.
Using an alternator from a 1998-02 Camaro- mount the billet rear brace as shown.
Camaro-GTO appliactions will not use a spacer between the alternator and the rear brace.
Mount the pulley on the front of the bracket.
When used with our LS1 style high mount power steering bracket uses Gates belt K060790.
This is the same belt as a stock 1998-02 Camaro LS1.