Using the provided metric 10MM counter sunk bolts, install these to the drivers side block.

If you have multiple mounting holes, LSX or Cadillac block, these mount to the front four holes.

Lube bolts and torque to 32 ft lbs.

Next, mount your 1996-2004 4.6 Mustang drivers side engine mount to the outer plate.

Use the provided Grade-8 zinc coated bolts that came installed in the top plate.

The Grade-8 washer is placed on top of the mount.

Torque all bolts to 32 ft lbs. These will fit the factory rubber or aftermarket urethane or solid engine mounts.

Align the slots in the top plate over the studs on the base plate.

Place one Grade-8 washer and one Grade-8 nylock locking nut over each stud.

You will have to slide the mount back and forth to get ample clearance to install these nuts.

Finger tighten- do not torque.

There is a large billet spacer that is installed into the 4.6 engine mount stud before placing the mounts into the Factory Fox K-member slots.

Drop engine onto cross member and install nuts on the 4.6 mounts. When you have the engine placed into the desired position, tighten the three locking nuts on the top plates to 32 ft lbs.